Management Port Connector Pinout Information For Acx Series Routers - Juniper ACX1000 Hardware Manual

Table 24: Alarm Contact Connector Pinouts
Pin Signal Definition
Number
15 ALARM_OUT2_NO/NC
SEE ALSO
ACX1000 and ACX1100 Universal Metro Router Overview | 2
Front Panel of an ACX1000 Router | 48
LEDs on ACX1000 and ACX1100 Routers | 55
Alarm Contact Port on ACX1000 and ACX1100 Routers | 45

Management Port Connector Pinout Information for ACX Series Routers

The management port— labeled MGMT— on an ACX Series router uses an RJ-45 connector to connect
to a management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100BASE-T connection. Two LEDs
indicate link activity on the port and the administrative status of the port.
Table 25 on page 88 provides the pinout information for the RJ-45 connector for the management
port.
Table 25: Management Port Connector Pinout Information
Pin Description
1 TRD[0]-
2 TRD[0]+
3 TRD[1]-
(Continued)
Direction CLI Port Mapping
Output Reserved for
Major alarm
Function
External alarm output 2 (this pin is
connected to Pin 9 in closed condition)
Direction
In/Out
In/Out
In/Out
88