Figure 37: Measurements For Installing Mounting Screws For The Ex2200-C; Switch - Juniper EX2200 Series Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches
92
To mount the switch on a wall:
Remove the switch from the shipping carton (see
1.
page 72).
Drill three holes A, B, and C on the wall as shown in
2.

Figure 37: Measurements for Installing Mounting Screws for the EX2200-C

Switch

.536 "
(1.36 cm)
A
3.98 "
(10.13 cm)
P
4.37"
(11.0 cm)
Drill hole A and install a mounting screw.
a.
Drill hole B 9.52 in. (22.1 cm) on a level line from hole A and install a mounting
b.
screw.
Mark a point P 3.98 in. (10.13 cm) on a plumb line down from hole A.
c.
From point P 4.37 in. (11.0 cm) on a level line drill hole C and install a mounting
d.
screw.
Tighten the screws only part way in, leaving about 1/4 in. (6 mm) distance between
3.
the head of the screw and the wall.
Mount the switch on the mounting screws facing front panel downwards, and slide it
4.
downward until it locks in place as shown in
"Unpacking an EX2200 Switch" on
Figure 37 on page
9.52"
(22.1 cm)
C
Figure 38 on page
Copyright © 2011, Juniper Networks, Inc.
92.
B
3.98 "
(10.13 cm)
93.