Figure 57: Lcd Panel In An Ex3200, Ex4200, Ex4500, Or Ex8200 Switch - Juniper EX2200 Series Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches
132
This topic describes the J-Web procedure.
NOTE: Before you begin the configuration, enable a DHCP client on the
management PC you will connect to the switch so that the PC can obtain an
IP address dynamically.
NOTE: Read the following steps before you begin the configuration. You
must complete the initial configuration using EZSetup within 10 minutes. The
switch exits EZSetup after 10 minutes and reverts to the factory default
configuration, and the PC loses connectivity to the switch.
EX2200 switch—The LEDs on the network ports on the front panel blink
when the switch is in the initial setup mode.
EX3200, EX4200, EX4500, or EX8200 switch—The LCD panel displays a
count-down timer when the switch is in initial setup mode.
To connect and configure the switch using the J-Web interface:
Transition the switch into initial setup mode:
1.
EX2200 switch—Press the mode button located on the lower right corner of the
front panel for 10 seconds.
EX3200, EX4200, EX4500, or EX8200 switch—Use the Menu and Enter buttons
located to the right of the LCD panel (see

Figure 57: LCD Panel in an EX3200, EX4200, EX4500, or EX8200 Switch

Press the Menu button until you see MAINTENANCE MENU. Then press the
1.
Enter button.
Press Menu until you see ENTER EZSetup. Then press Enter.
2.
If EZSetup does not appear as an option in the menu, select Factory Default to
return the switch to the factory default configuration. EZSetup is displayed in
the menu of standalone switches only when a switch is set to the factory default
configuration.
Press Enter to confirm setup and continue with EZSetup.
3.
Connect the Ethernet cable from the Ethernet port on the PC to the switch.
2.
EX2200, EX3200, or EX4200 switch—Connect the cable to port 0 (
the front panel of the switch.
Figure 57 on page 132):
ge-0/0/0
Copyright © 2011, Juniper Networks, Inc.
) on