Unpacking An Ex2200 Switch - Juniper EX2200 Series Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches
Related
Documentation

Unpacking an EX2200 Switch

72
"Mounting an EX2200 Switch On or Under a Desk Using Screws" on page 78
the desk/wall mounting screws)
"Mounting an EX2200 Switch Using the Magnet Mount" on page 94
separately orderable magnet sheet)
Follow instructions in "Connecting Earth Ground to an EX Series Switch" on page
3.
Follow instructions in "Connecting AC Power to an EX2200 Switch" on page 109
4.
"Connecting DC Power to an EX2200 Switch" on page
Perform initial configuration of the switch by following instructions in
5.
and Configuring an EX Series Switch (CLI Procedure)" on page 129
Configuring an EX Series Switch (J-Web Procedure)" on page
Set the switch's management options by following the appropriate instructions:
6.
Connecting an EX Series Switch to a Network for Out-of-Band Management on
page 113
Connecting an EX Series Switch to a Management Console on page 115
Rack Requirements for EX2200 Switches on page 57
Cabinet Requirements for EX2200 Switches on page 58
Clearance Requirements for Airflow and Hardware Maintenance for EX2200 Switches
on page 60
The EX2200 switches are shipped in a cardboard carton, secured with foam packing
material. The carton also contains an accessory box.
CAUTION: EX2200 switches are maximally protected inside the shipping
carton. Do not unpack the switches until you are ready to begin installation.
To unpack the switch:
Move the shipping carton to a staging area as close to the installation site as possible,
1.
but where you have enough room to remove the system components.
Position the carton so that the arrows are pointing up.
2.
Open the top flaps on the shipping carton.
3.
Remove the accessory box and verify the contents in it against the parts inventory on
4.
the label attached to the carton.
Pull out the packing material holding the switch in place.
5.
(using the
110.
"Connecting
or "Connecting and
131.
Copyright © 2011, Juniper Networks, Inc.
(using
103.
or