Figure 34: Attaching Wall-Mount Brackets To A Switch Chassis - Juniper EX2200 Series Hardware Manual

Copyright © 2011, Juniper Networks, Inc.
Before mounting the switch on a wall:
Verify that the site meets the requirements described in
for EX2200 Switches" on page
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines for EX2200 Switches" on page
Ensure that you have the following parts and tools available:
2 wall-mount brackets (provided in the wall-mount kit)
1 wall-mount baffle (provided in the wall-mount kit)
12 wall-mount bracket screws (provided in the wall-mount kit)
6 mounting screws (8-32 x 1.25 in. or M4 x 30 mm) (not provided)
Hollow wall anchors rated to support up to 75 lb (34 kg) if you are not screwing the
screws directly into wall studs (not provided)
Phillips (+) screwdriver, number 2
To mount one or two switches on a wall:
Remove the switch from the shipping carton (see
1.
page 72).
Attach the wall-mount brackets to the sides of the chassis using four wall-mount
2.
bracket screws on each side, as shown in

Figure 34: Attaching Wall-Mount Brackets to a Switch Chassis

Rear panel
Front panel
If you are mounting two switches together, align the second switch on top of the first
3.
and attach it to the mounting brackets using two additional wall-mount bracket
screws on each side. (Figure 36 on page 91
Install four mounting screws in the wall for the wall-mount brackets (and two more
4.
for the baffle if you are installing a switch that supports PoE) as shown in
on page 90:
51.
Figure 34 on page
Baffle for PoE Models
(EX2200-24P and EX2200-48P)
shows two aligned switches.)
Chapter 8: Installing the Switch
"Site Preparation Checklist
155, with particular attention
166.
"Unpacking an EX2200 Switch" on
89.
Figure 35
89