Figure 35: Measurements For Installing Mounting Screws - Juniper EX2200 Series Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches
90
Use hollow wall anchors rated to support up to 75 lb (34 kg) if you are not inserting
the mounting screws directly into wall studs.
Turn the screws only part way in, leaving about 1/4 in. (6 mm) distance between
the head of the screw and the wall.
Install screw A.
a.
Install screw B 18.68 in. (47.4 cm) from screw A on a level line.
b.
Install screw C 5.98 in. (15.2 cm) on a plumb line down from screw A and screw D
c.
5.98 in. down from screw B.
For PoE models, install screw E 2.76 in. (7 cm) up from and 8.32 in. (21.1 cm) to the
d.
right of screw A.
For PoE models, install screw F 4.49 in. (11.4 cm) to the right of screw E.
e.

Figure 35: Measurements for Installing Mounting Screws

Rear
8.32 in. (21.1 cm)
2.76 in (7 cm)
A
5.98 in.
(15.2 cm)
C
Front
Lift the unit (one switch or two) by grasping each side, and hang the unit by attaching
5.
the brackets to the mounting screws as shown in
For PoE models, install the baffle by attaching it to screws E and F.
6.
Tighten all mounting screws.
7.
Baffle for PoE Models
(EX2200-24P and EX2200-48P)
18.68 in. (47.4 cm)
4.49 in.
(11.4 cm)
E F
Side wall-mount brackets
Figure 36 on page
Copyright © 2011, Juniper Networks, Inc.
B
D
91.