Figure 44: Installing A Transceiver In An Ex Series Switch - Juniper EX2200 Series Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches
100
To install a transceiver in an EX Series switch:
CAUTION: To avoid electrostatic discharge (ESD) damage to the transceiver,
do not touch the connector pins at the end of the transceiver.
Remove the transceiver from its bag.
1.
Check to see whether the transceiver is covered by a rubber safety cap. If it is not,
2.
cover the transceiver with a rubber safety cap.
WARNING: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing a cable. The rubber safety cap keeps the port clean
and prevents accidental exposure to laser light.
If the port in which you want to install the transceiver is covered with a dust cover,
3.
remove the dust cover and save it in case you need to cover the port later. If you are
hot-swapping a transceiver, wait for at least 10 seconds after removing the transceiver
from the port before installing a new transceiver.
Using both hands, carefully place the transceiver in the empty port. The connectors
4.
must face the switch chassis.
CAUTION: Before you slide the transceiver into the port, ensure the
transceiver is aligned correctly. Misalignment might cause the pins to
bend, making the transceiver unusable.
Slide the transceiver in gently until it is fully seated.
5.
Remove the rubber safety cap when you are ready to connect the cable to the
6.
transceiver.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.

Figure 44: Installing a Transceiver in an EX Series Switch

Copyright © 2011, Juniper Networks, Inc.