Figure 21: Attaching Rubber Feet To A Switch Chassis - Juniper EX2200 Series Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches
76
Place the desk in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines for EX2200 Switches" on page
NOTE: Do not block the vents on the top of the EX2200-C switches. Doing
this can lead to overheating of the switch chassis.
Ensure that you have the following parts and tools available:
4 rubber feet to stabilize the chassis on the a desk or other level surface (provided in
the accessory box in the switch carton)
1 cable guard and 3 number-8 Phillips truss-head screws (optional and separately
orderable) to secure the cable guard to the EX2200-C switch
1 standard cable lock (optional and separately orderable) to secure the EX2200-C
switch models only from theft by connecting the cable to the security slots on the
switch
To mount a switch on a desk or other level surface:
Remove the switch from the shipping carton (see
1.
page 72).
Turn the chassis upside down on the desk or the level surface where you intend to
2.
mount the switch.
Attach the rubber feet to the bottom of the chassis, as shown in
3.
Turn the chassis right side up on the desk or the level surface.
4.

Figure 21: Attaching Rubber Feet to a Switch Chassis

(Optional; applies only to EX2200-C models) Attach the cable guard to protect cable
5.
connections:
Use the 3 truss-head screws to attach the cable guard to the bottom of the chassis.
a.
Use the thumbscrews to tighten or loosen the guard to allow you to insert cables.
b.
See Figure 22 on page
"Unpacking an EX2200 Switch" on
Rubber feet
77.
155, with particular attention
166.
Figure 21 on page
Copyright © 2011, Juniper Networks, Inc.
76.