Figure 32: Mounting The Switch To The Front Posts Of A Rack; Figure 33: Sliding The Rear Brackets To The Rear Of A Four-Post Rack - Juniper EX2200 Series Hardware Manual

Related
Documentation
Copyright © 2011, Juniper Networks, Inc.

Figure 32: Mounting the Switch to the Front Posts of a Rack

Have a second person secure the front of the switch to the rack by using the appropriate
8.
screws for your rack.
Slide the rear brackets into the side-rail brackets. See
9.

Figure 33: Sliding the Rear Brackets to the Rear of a Four-Post Rack

Rear brackets
Attach the rear brackets to the rear post by using the appropriate screws for your rack.
10.
Tighten the screws.
Ensure that the switch chassis is level by verifying that all the screws on the front of
11.
the rack are aligned with the screws at the back of the rack.
Connecting Earth Ground to an EX Series Switch on page 103
Connecting AC Power to an EX2200 Switch on page 109
Connecting DC Power to an EX2200 Switch on page 110
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 129
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 131
Switch
Side-rail Front
bracket bracket
Side-rail
bracket
Chapter 8: Installing the Switch
Figure 33 on page 87.
Switch
87