Console/Auxiliary Port Connector Pinout On Acx Series Routers; Management Port Connector Pinout Information For Acx Series Routers; Alarm, Management, And Clocking Cable Specifications And Pinouts; Table 27: Connector Pinout For The Console/Auxiliary Port - Juniper ACX1000 Hardware Manual

Console/Auxiliary Port Connector Pinout on ACX Series Routers

Related
Documentation

Management Port Connector Pinout Information for ACX Series Routers

Copyright © 2017, Juniper Networks, Inc.
Chapter 12: Alarm, Management, and Clocking Cable Specifications and Pinouts
The port on the front panel labeled
that accept an RJ-45 connector. Use a cable with the pinouts described in
Table 27 on page 73 to connect the Routing Engine to an auxiliary or console management
device.
NOTE: You must use a shielded twisted pair (STP) cable for both outdoor
and indoor deployments.

Table 27: Connector Pinout for the Console/Auxiliary Port

Pin Signal
1 RTS
2 TXD
3 TXD
4 Ground
5 Ground
6 RXD
7 RXD
8 CTS
Management Port Connector Pinout Information for ACX Series Routers on page 73
The management port on an ACX Series router labeled
to connect to a management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100Base-T connection.
Two LEDs indicate link/activity on the port and the administrative status of the port.
Table 28 on page 74 provides the pinout information for the RJ-45 connector for the
management port.
is an asynchronous serial interface
CONSOLE/AUX
Description CPU
Request to Send Routing Engine
Transmit Data 1588 CPU
Transmit Data Routing Engine
Signal Ground –
Signal Ground –
Receive Data Routing Engine
Receive Data 1588 CPU
Clear to Send Routing Engine
MGMT
Direction
Out
Out
Out
–
–
In
In
In
uses an RJ-45 connector
73