Figure 60: Attaching Front-Mounting Brackets - Juniper QFX10016 Hardware Manual

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Lift the chassis approximately 0.75 in. (1.9 cm) above the surface of the mounting
4.
brackets. Align the chassis as close as possible to the mounting brackets.
Carefully slide the chassis onto the adjustable mounting brackets until the
5.
front-mounting brackets attached to the chassis contact the rack rails. The mounting
brackets ensure that the holes in the front-mounting brackets align with the holes in
the rack rails. See Figure 60 on page

Figure 60: Attaching Front-Mounting Brackets

Move the lift away from the rack.
6.
Install a mounting screw into each of the open front-mounting holes aligned with the
7.
rack, starting from the bottom.
Visually inspect the alignment of the switch. If the switch is installed properly in the
8.
rack, all the mounting screws on one side of the rack are aligned with the mounting
screws on the opposite side and the switch is level.
After ensuring that the switch is aligned properly, tighten the screws.
9.
Connecting AC Power to a QFX10000 on page 165
Connecting DC Power to a QFX10000 on page 165
Configuring a QFX10000 on page 171
Chapter 12: Unpacking and Mounting the Switch
155.
155