Table of Contents
Advertisement
1. Attach the mounting blades to the front rack posts using six rack mount screws.
2. From the rear of the rack, slide the mounting tray into the rear posts of the rack such that the
mounting blades align below the flanges on either sides of the mounting tray.
3. Attach the tray to the rear rack posts using eight rack mount screws.
4. Attach the tray to the mounting blades in the rack using the 12 flat-head screws.
Mount the PTX10004 on a the Rack and Ground the Chassis
1.
Wrap and fasten one end of the electrostatic discharge (ESD) grounding strap around your bare
wrist, and connect the other end to a site ESD point.
2.
Load the router onto the lift, making sure it rests securely on the lift platform.
3.
Align the router in front of the rack, centering it in front of the mounting tray.
4.
Lift the chassis approximately 0.75 in. (1.9 cm) above the surface of the mounting tray. Align the
chassis as close as possible to the mounting tray.
5.
Carefully slide the chassis onto the shelf until the chassis flanges contact the rack rails.
6.
Starting at the bottom, attach the chassis to the rack by inserting eight rack mount screws through
each open flange hole and rack hole.
3
Advertisement
Table of Contents
