Attaching The Mounting Brackets - Juniper MX204 Hardware Manual

MX204 3D Universal Edge Router Hardware Guide
66
Figure 20: Attaching the Mounting Brackets
Using a Phillips (+) number 2 screwdriver, secure the mounting brackets to the router
4.
using the mounting screws.
With one person on each side, hold on to the bottom of the chassis and carefully lift
5.
it so that the mounting brackets contact the rack rails.
Carefully slide the router onto the mounting brackets until the front-mounting brackets
6.
attached to the chassis contact the rack rails (see
Figure 21: Installing the Router in a Four-Post Rack
Install mounting screws into each of the open front-mounting holes aligned with the
7.
rack, starting from the bottom, and secure them tightly.
the router fully secured to the front rails of the four-post rack.
Figure 22: Router Secured by Front-Mounting Brackets
On the rear of the chassis, slide the rear-mounting brackets on either side of the chassis
8.
until the rear-mounting brackets contact the rack rails (see
Figure 21 on page 66).
Figure 22 on page 66
Figure 23 on page
Copyright © 2018, Juniper Networks, Inc.
shows
67).