Advertisement
Copyright © 2017, Juniper Networks, Inc.
NOTE:
Each side of the chassis has twelve holes for attaching the
front-mounting brackets to the device.
Six holes on the chassis side align with six holes in the front bracket when
the front bracket is mounted flush with the chassis front or recessed 2 in.
from the front of the chassis.
Insert M4x6-mm Phillips flat-head mounting screws into the two aligned holes and
3.
tighten the screws. Ensure that the remaining two holes in the front bracket are aligned
with the two holes in the side panel. See
Figure 14: Attaching the Front-Mounting Bracket to the Chassis
Insert M4x6-mm Phillips flat-head mounting screws into the remaining two holes in
4.
the front bracket and tighten the screws.
Repeat Step 2 through Step 4 for attaching the front-mounting bracket to the other
5.
side of the chassis.
Have one person grasp both sides of the device, lift the device, and position it in the
6.
rack, aligning the front bracket holes with the threaded holes in the front post of the
rack. Align the bottom hole in both the front-mounting brackets with a hole in each
rack rail, making sure the chassis is level. See
Figure 15: Mounting the MX150 on the Front Posts in a Rack
Have a second person secure the front of the device to the rack by using the appropriate
7.
screws for your rack.
Chapter 10: Installing the MX150
Figure 14 on page
83.
Figure 15 on page
83.
83
Advertisement
Chapters
