Configuring Aeroscout Parameters - Motorola RFS Series Reference Manual

Once SOLE has been enabled MUs found by the locationing engine will be displayed in the
table at the bottom of the page. For each located MU the following information is displayed:
MAC
Location:
X Coordinate
Location:
YCoordinate
Timestamp
Zone
NOTE: Zone configuration can be defined using the CLI interface only. For information on Zone
Configuration please see the Motorola RF Switch CLI Reference.

5.8.5 Configuring Aeroscout Parameters

To configure the switch to work with an external Aeroscout RTLS engine:
1. .Services > RTLS
2. Select the Aeroscout
3. Check the Enable
This takes effect immediately when the box is checked.
Lists the MAC Addresses of all MUs which have been located by the switch.
Displays the value of the X Coordinate for each located MU. The X coorinate is
relative to the origin point of 0,0 in the upper left corner of the site map.
Displays the value of the Y Coordinate for each located MU. The Y coorinate is
relative to the origin point of 0,0 in the upper left corner of the site map.
Displays the last time for each MU that its location was computed by the switch.
Lists the last known zone for each located MU. Zone configuration can be defined
using the CLI interface only. When no zones are configured, the switch defaults
the entire site to Zone 0.
from the main menu tree.
tab.
checkbox to globally enable Aeroscout RTLS support on the switch.
5-69
Switch Services
Located MUs