Motorola RFS Series Reference Manual page 110

4-22 Motorola RF Switch System Reference Guide
2. Click the Configuration
The Configuration tab displays the following details:
Switch
Index
Enabled
ESSID
Description
VLAN(s)
Authentication
tab.
The Switch field displays the IP address of the cluster member associated with
each WLAN. When clustering is enabled on the switch and
enabled the Switch field will be available on the Wireless LAN screen. For
information on configuring enabling
the Web UI.
Displays the WLAN's numerical identifier. The WLAN index range is from 1 to the
maximum number of WLANs supported by the switch. An index can be helpful to
differentiate a WLAN from other WLANs with similar configurations.
Refer to the Enabled parameter to discern whether the specified WLAN is enabled
or disabled. When enabled, a green check mark displays. When disabled, a red "X"
displays. To enable or disable a WLAN, select it from the table and click the Enable
or Disable button.
Displays the Service Set ID associated with each WLAN. Click the Edit button to
modify the value to a new unique SSID.
Displays a short description of the associated WLAN. Click the Edit button to
modify the value the WLAN description.
Displays the name of the VLAN ID(s) of the VLAN(s) this WLAN is mapped to. The
VLAN ID can be between 1 and 4094. The default mapping is to a single VLAN with
VLAN ID 1.
Displays the type of authentication used with the specified WLAN. Click the
button to modify the WLAN's current authentication scheme. For information on
configuring an authentication scheme for a WLAN, see
Authentication Types on page
Cluster GUI, see Managing Clustering Using
Configuring
4-32.
Cluster GUI is
Edit