Motorola RFS Series Reference Manual page 312

5-72 Motorola RF Switch System Reference
4. Enter the Multicast MAC Address
address specified. Typically the MAC address will start with 01-0C-CC-XX-XX-XX.
NOTE: To use the onboard SOLE engine to locate Newbury tags, site parameters, AP
location (Command Line Interface only) and Zone configuration (optional, Command Line
Interface only) must be configured.
5. Specify the
6. Enter the Port
between 1000 and 9000.
7. Click the Apply
8. Click the Revert
Port settings and revert back to the last saved configuration.
9. If the Multicast MAC Address, IP Address
is enabled the following information will be displayed:
No. of RX Msgs
Last Msg RX Time
No. of TX Msgs
Last Msg TX Time
No. of Tag Reports
10.To use the onboard SOLE engine to locate Newbury tags check the
immediately after checking the box.
11.If the onboard SOLE engine is enabled to locate Newbury tags, enter a
specify how often the known tags are located by the SOLE engine.
12.Click the Apply
13.Click the Revert
the last saved configuration.
used for all Newbury tags to send updates via multicast to the MAC
IP Address of the Newbury RTLS engine server.
number used to communicate with the Newbury RTLS engine. The port range must be
button to save the Multicast MAC Address, IP Address
button to cancel any changes made within
Displays the number of messages received by the switch from the external
Newbury RTLS engine.
Displays the Date and Time that the last message was received from the external
Newbury RTLS engine.
Displays the number of messages transmitted by the switch to the external
Newbury RTLS engine.
Displays the Date and Time that the last message was sent to the external
Newbury RTLS engine.
Displays the number of Tag Reports received from the external Newbury RTLS
engine.
button to save the Locate Interval
button to cancel any changes made within
Multicast MAC Address, IP Address
and Port values are configured and Newbury RTLS support
Enable
Locate Interval
value.
Locate Interval
and Port information
and
checkbox. This is enabled
in seconds to
value and revert back to