Motorola RFS Series Reference Manual page 427

2. Click the Email Configuration
servers and and addresses for alerts.
3. Check the Enable SMTP
notification on the switch, this box must be checked.
Configure the SMTP mail server properties as follows:
Name Enter the hostname of your outgoing SMTP mail server. This is the server that is
used to deliver outgoing mail.
Port Specify the port number used by your outgoing SMTP server. In many cases this is
port 25.
User Name Enter the username for the user which will be sending outgoing mail through the
SMTP server.
Password Enter the password associated with the above username.
Enable Authentication Check the Enable Authentication box to enable support for SMTP Authentication
which is required for certain outgoing SMTP servers.
4. Configure the mail-to section of the page as follows:
To Address(es) Specify an e-mail address or addresses that notifications will be sent to. To add an
e-mail address to the list, enter the email address in the To Address(es) field and
click the Add button. There is a maximum of 4 e-mail addresses allowed on the list.
Add Click the Add button to add an e-mail address that is in the To Address(es) field to
the list below.
Remove Select an e-mail address from the list and click the Remove button to delete that
address from the list.
button to launch a dialogue where you can configure outgoing E-mail
box to enable the outgoing mail server on the switch. In order to use E-mail
7-13
Switch Management