Motorola RFS Series Reference Manual page 83

4. Refer to the Firmware
enabled, the located (updated) switch firmware is used with the switch the next time the switch boots.
Enable Select the
(updated) version is detected (upon the boot of the switch) at the specified IP
address.
IP Address Define the
version is detected when the switch is booted it will be uploaded to the switch
and used upon the next boot of the switch.
User ID Enter the
File Name (With Provide the complete and accurate path to the location of the firmware files on the
Path) server. This path must be accurate to ensure the file is retrieved.
Protocol Use the
resident switch
the default setting.
Password Enter the password required to access the server.
Version Provide the target firmware version to ensure the switch is upgrading to the
intended baseline.
5. Select the Start Update
configuration or firmware facilities.
6. Click the Apply button to save the changes to the configuration.
7. Click the Revert button to revert back to the last saved configuration.
field to enable and define the configuration for automatic firmware updates. If
Enable checkbox to allow an automatic firmware update when a new
IP address of the server where the firmware files reside. If a new
User ID required to access the FTP or TFTP server.
Protocol drop-down menu to specify the
FLASH medium used for the file update from the server. FLASH is
button to begin the file updates for the enabled switch configuration, cluster
Switch Information
FTP, TFTP, HTTP, SFTP or
3-39