Motorola RFS Series Reference Manual page 145

3. Refer to the following details displayed within the table:
Last 30s
Last Hr
Index
ESSID
Descr
VLAN
MUs
Throughput Mbps
Avg BPS
% Non-UNI
Retries
4. To view WLAN statistics in greater detail, select a WLAN and click the
information, see
NOTE: When using mesh enabled WLAN statistics, no statistics are shown. This is
because WLAN statistics are generated by mobile unit traffic for that particular WLAN. In
a mesh configuration, there are typically no mobile units associated and therefore no
statistical information to display.
5. To view WLAN statistics in a graphical format, select a WLAN and click the
information, see
6. To view WLAN packet data rates and retry counts, select a WLAN and click the
button. For more information, see
4.5.2.1 Viewing WLAN Statistics in Detail
When the WLAN Statistics screen does not supply adequate information for an individual WLAN, the
Details screen is recommended for displaying more granular information for a single WLAN. Use this
information to discern if a WLAN requires modification to meet network expectations.
To view detailed statistics for a WLAN:
1. Select a Network
2. Click the Statistics
Click the Last 30s radio button to display statistics for the WLAN over the last 30
seconds. This option is helpful when troubleshooting issues as they actually occur.
Click the Last Hr radio button to displays statistics for the WLAN over the last 1
hour. This metric is helpful in baselining events over a one hour interval.
The Idx (or index) is a numerical identifier used to differentiate the WLAN from
other WLANs that may have similar characteristics.
The SSID is the Service Set ID (SSID) for the selected WLAN.
The Descr item contains a brief description of the WLAN. Use the description
(along with the index) to differentiate the WLAN from others with similar
attributes.
The VLAN parameter displays the name of the VLAN the WLAN is associated with.
Lists the number of MUs associated with the WLAN.
Throughput Mbps is the average throughput in Mbps on the selected WLAN. The
Rx value is the average throughput in Mbps for packets received on the selected
WLAN. The Tx value is the average throughput for packets sent on the selected
WLAN.
Displays the average bit speed in Mbps for the selected WLAN. This includes all
packets sent and received.
Displays the percentage of the total packets for the selected WLAN that are non-
unicast packets. Non-unicast packets include broadcast and multicast packets.
Displays the average number of retries for all MUs associated with the selected
WLAN.
Viewing WLAN Statistics in Detail on page
Viewing WLAN Statistics in a Graphical Format on page
Viewing WLAN Switch Statistics on page
> Wireless LANs from the main menu tree.
tab.
Network Setup
Statistics button. For more
4-57.
Graph button. For more
4-60.
Switch Statistics
4-61.
4-57