Motorola RFS Series Reference Manual page 236

4-148 Motorola RF Switch System Reference Guide
Admin Edge Port
Oper Edge Port
Admin Point-to-Point
Oper Point-to-Point
3. Select an Id and click the
4.10.3.1 Editing a MSTP Port Configuration
To edit and reconfigure MSTP Port parameters.
1. Select a row from the port table and click the
The following MSTP Port parameters can be reconfigured.
Port Index
Admin MAC Enable
Port auto Edge
Port Guard Root
PortFast BPDU Filter
A green checkmark defines the listed index enabled as an Admin Edge Port, and a
red "X" defines the listed index as not being an Admin Edge Port. Enable it only on
ports that connect to a single location.
Oper Edge Port Displays whether the port is currently an edge port.
Displays the point-to-point status as ForceTrue or ForceFalse. ForceTrue indicates
this port should be treated as connected to a point-to-point link. ForceFalse
indicates this port should be treated as having a shared connection.
Displays whether the listed port index is configured to connect to another port
through a point-to-point link. A green checkmark indicates the port as supporting
point-to-point, and a red "X" indicates the port as having point-to-point disabled.
Edit button to revise the selected MSTP port configuration.
Displays the read-only Port Index.
Displays the status of the Admin MAC Enable. A green check mark indicates the
status as enabled.
Select the checkbox to use the port as an edge port.
Port Guard Root Select this checkbox to enable guard root for this port. Typically,
each guard root port is a designated port, unless two or more ports (within the root
bridge) are connected together. If the bridge receives superior (BPDUs) on a guard
root-enabled port, the guard root moves the port to a root-inconsistent STP state.
This state is equivalent to a listening state. No data is forwarded across the port.
Thus, the guard root enforces the root bridge position.
Enable this option to change the status of the Port Fast BPDU Filter.
Edit button.