Motorola RFS Series Reference Manual page 322

6-8 Motorola RF Switch System Reference Guide
2. Click on the
3. The Unapproved APs (AP Reported)
BSS MAC Address
Reporting AP
Channel
Signal Strength (in
dbm)
Last Seen (in
Seconds)
ESSID
4. The Number of Unapproved APs
detected.
5. If a radio's MAC address is listed incorrectly, highlight the MAC Address and click the
Assign an Index and define the required device address information to move the device into the list of
approved Access Point MAC addresses. The number of Unapproved APs updates accordingly as devices
are added and removed.
6. Click the Export
Unapproved APs (AP Reported)
Displays the MAC Address of each Unapproved AP. These MAC addresses are
Access Points observed on the network, but have yet to be added to the list of
Approved APs, and are therefore interpreted as a threat on the network.
If a MAC Address displays on the list incorrectly, click the
the MAC Address of a newly Allowed AP index.
Displays the numerical value for the radio used with the detecting AP.
Displays the channel the Unapproved AP is currently transmitting on.
Displays the Relative Signal Strength Indicator (RSSI) for the detected (and
unapproved) AP. AP's with a strong signal may pose a more significant risk within
the switch managed network.
Displays the time (in seconds) the Unapproved AP was last seen on the network
by the detecting AP.
Displays the ESSID of each Unapproved AP. These ESSIDs are device ESSIDs
observed on the network, but have yet to be added to the list of Approved APs and
are therefore interpreted as a threat. If an ESSID displays on the list incorrectly,
click the Allow button and add the ESSID to a new Allowed AP index.
is simply the sum of all of Unapproved Radio MAC Addresses
button to export the contents of the table to a Comma Separated Values file (CSV).
tab.
table displays the following information:
Allow button and add
Allow button.