Configuring Secure Shell Connection Parameters; Admin Authentication And Radius Server Authentication Setup; Setting Up Airbeam Software Access - Motorola WS2000 System Reference Manual

6-4 WS2000 Wireless Switch System Reference Guide
WS2000 Certificate
Use the WS2000 Certificate
WS2000 Wireless Switch. The 'default' certificate is used by default. To use other certificates, it must be
installed on the WS2000 before it can be used.
Management Access across subnet
To allow administrators to access the switch from other subnets, check this box. To disallow management
access to this switch from other subnets, this check box must not be checked.

6.1.2 Configuring Secure Shell Connection Parameters

If CLI SSH (port 22)
1. Enter a value, in seconds, when a client connected via SSH must reauthenticate in the
Timeout field. The default is 120 seconds (2 minutes).
2. Enter the amount of time, in seconds, when an inactive client using SSH will be disconnected in the
Client Inactivity Timeout
3. If it is required to provide support for using SSH v 1, select the

6.1.3 Admin Authentication and RADIUS Server Authentication Setup

There are two methods available for authenticating administrators upon connecting to the switch. Use this
area to set up the desired authentication methods.
• Select the
in password authentication process (that is, using the standard admin password).
• Select the
If RADIUS is selected, then the RADIUS server information can be entered in the
for Admin Authentication
• Select the
authenticated using the local RADIUS server. This indicates that any AirBEAM user will be
authenticated with the users listed with the onboard RADIUS server.
If the RADIUS button is selected, specify the
authentication process, and the RADIUS server's

6.1.4 Setting Up AirBEAM Software Access

Motorola's AirBEAM software suite is a comprehensive set of mobility management tools that maximize the
availability, security and effectiveness of a wireless network. The fields in this section of the screen allow
the administrator to enable access from the AirBEAM software suite and to set the AirBEAM password.
1. To enable AirBEAM access, check the
2. Specify a password for AirBEAM software access. Note that the AirBEAM login name is always
"airbeam".
3. Click the Apply
drop down list to select the security certificate to use for accessing the
is enabled either on WAN or LAN, set the fields in the Secure Shell area:
field. The default is 120 seconds (2 minutes).
Local radio button to have the administrator of the switch authenticate using the built-
RADIUS radio button to have the administrator authenticate against a RADIUS database.
area.
Authenticate AirBEAM user using Local DB
Enable AirBEAM
button to save changes.
SSHv1 Support
check box to allow AirBEAM users to be
RADIUS Server IP address, the communication port for the
Shared Secret (password) to use.
check box.
Authentication
SSH
to enable it.
RADIUS Server