Motorola RFS Series Reference Manual page 278

5-38 Motorola RF Switch System Reference
3. To enable Dynamic AP Load Balancing
configure the parameters below:
Runtime/Schedule
Start Date
Start Time
Interval
MU Threshold
4. Once Dynamic Load Balancing parameters are set, click the
AP Load Balancing.
5. Managing clustering in the Web UI is done through the
GUI checkbox to enable this feature. The
allowing you to see APs and MUs managed by all active members of a cluster.
6. Refer to the
State
Time
Trigger
Description
7. Click Apply
Apply button results in all the changes on the screen being discarded.
8. Click the Revert
Select Runtime or Schedule to determine when load balancing will run. If Runtime
is selected, load balancing will initiate anytime a new active switch is added to
the redundancy group. If Schedule is selected you can configure a start date and
time to execute load balancing. This feature is not available when Dynamic Load
Balancing is enabled.
If Schedule is selected as the load balancing mode, enter a start date for load
balancing to take place.
If Schedule is selected as the load balancing mode, enter a start time for load
balancing to take place.
If Schedule is selected as the load balancing mode, enter an interval (in days) for
how often load balancing should take place. The valid range is between 1 and 180
days.
The MU threshold specifies the number of minimum number of active MUs on an
AP to stop the AP from resetting for load balancing.
History field to view the current state of the redundancy group.
Displays the new state (status) of the redundancy group after a Trigger event has
occurred.
Displays the Timestamp (time zone specific) when the state change occurred.
Displays the event causing the redundancy group state change on the switch.
Displays a redundancy event description defining the redundancy group state
change on the switch. Typical states include Redundancy Disabled or Redundancy
Enabled.
to save any changes to the screen. Navigating away from the screen without clicking the
button to undo the changes to the screen and revert to the last saved configuration.
check the Enable Dynamic AP Load Balancing
Dynamic AP LB Now
Cluster GUI
Cluster GUI feature updates many key screens in the Web UI
box and
button to run Dynamic
feature. Check the Enable Cluster