Motorola RFS Series Reference Manual page 58

3-14 Motorola RF Switch System Reference
2. Select the Configuration
Name
MAC Address
Admin Status
Speed
Duplex
SWITCH NOTE: On a RFS7000, the MAC address for the me1 port changes when the
switch firmware is updated to the 1.3 version. This addresses an issue where the switch
MAC address and ge1 interface shared the same MAC address in previous versions.
3. Select a port and click the
Editing the Port
3.2.1.1 Editing the Port Configuration
To modify the port configuration:
1. Select a port from the table displayed within the Configuration screen.
tab to display the following read-only information:
Displays the current port name. The port names available vary by switch.
WS5100: eth1, eth2
RFS6000: ge1, ge2, ge3, ge4, ge5, ge6, ge7, ge8, me1, up1
RFS7000: ge1, ge2, ge3, ge4, me1
Displays the port's MAC Address. This value is read-only, set at the factory and
cannot be modified.
Displays whether the port is currently Up or Down.
Displays the current speed of the data transmitted and received over the port.
Displays the port as either half or full duplex.
Edit button to modify the port configuration. For additional information, see
Configuration.