Motorola RFS Series Reference Manual page 206

4-118 Motorola RF Switch System Reference Guide
Remove
Number of Rescuers
Retry Threshold(avg
attempts/pkt)
Hold Time(seconds)
Assignable Power
Range(dBm)
Scan Dwell
Time(seconds)
7. The Monitoring/Recovery Configuration
Interference
Recovery
Faulty Radio
Recovery
Coverage Hole
Recovery
8. The Diagnostic Configuration
Verbose Mode
Extensive Scan
Mode
9. The Calibration Schedule
Schedule Calibration
Start Date
Start Time
Interval
10.Once the settings have been configured, click the
To remove a channel from the configured list, select one or more channesl from
the Available box and click the Remove button.
Assign a number of radios to dedicate as rescuers. The valid range is between 1
and 5.
Specify the retry threshold which is the average number of retries per packet to
cause a radio to re-run channel selection.
Specify the global hold time in seconds. The valid range is between 30 and 65535
seconds.
Specify a valid range for the power in dBm. The valid minimum is 4 and maximum
is 20.
Specify the RF Scan Dwell Time in seconds. The valid range is between 1 and 10
seconds.
section contains the following configuration items:
Check this box to enable monitoring for interference and self-healing it by rescuer.
Check this box to enable monitoring for defective radio and self-healing by its
rescuer.
Check this box to enable monitoring and recovering for coverage holes.
section contains the following two configuration items:
Check this box to enable verbose diagnostic information for Smart RF.
Check this box to enable extensive scan mode when using Smart RF.
contains the following calibration settings:
Check this box to enable scheduled RF Calibration.
If scheduled RF Calibration is enabled, enter a start date in MM/DD/YY format for
the start date of scheduled calibration.
If scheduled RF Calibration is enabled, enter a start time in HH:MM:SS format for
the start time of scheduled calibration.
If scheduled RF Calibration is enabled, enter an interval in days for how long the
scheduled calibration should continue after its start date.
Run Calibration button to start a Smart RF calibration.