Attaching An Acl On A Wlan Interface/Port - Motorola RFS Series Reference Manual

6-28 Motorola RF Switch System Reference Guide
6.5.3.1 Adding a New ACL Layer 2/Layer 3 Configuration
After creating an ACL, it can be applied to one or more interfaces. On a Layer 3 interface, it can be applied
in either an outbound or inbound direction, and only in an inbound direction on a Layer 2 interface. To add an
ACL interface to the switch:
1. Select Security
2. Click on the
3. Click the Add
4. Use the Interface
include – Ethernet 1, Ethernet 2, VLAN 1 (plus those VLANs created thus far) and Tunnel n (where n equals
the name(s) of those tunnels created thus far).
5. Use the IP ACL
interface.
6. Use the MAC ACL
7. Refer to the
messages if something goes wrong in the transaction between the applet and the switch.
8. Click OK to use the changes to the running configuration and close the dialog.
9. Click Cancel

6.5.4 Attaching an ACL on a WLAN Interface/Port

Use the Attach-WLAN
supported. Create a MAC ACL to allow arp on the switch.
NOTE: WLAN based ACLs allows users to enforce rules/ACLs on both the inbound and
outbound direction, as opposed to Layer 2 ACLs, which just support the inbound direction.
To configure a WLAN ACL:
1. Select Security
2. Click the Attach-WLAN
> Firewalls from the main menu tree.
Attach-L2/L3 tab.
button.
drop-down menu to select the interface to configure on the switch. Available options
drop-down menu to select an IP ACL used as the inbound IP for the layer 2 or layer 3
drop-down menu to select an MAC ACL used as the MAC IP for the layer 2 interface.
Status field for the state of the requests made from applet. This field displays error
to close the dialog without committing updates to the running configuration.
tab to view and assign an ACL to a WLAN on the switch. By default, arp is not
> Firewalls from the main menu tree.
tab.