Configuring System-Wide Settings
3. Enter data into the fields.
Table 13: Times Assist Configuration dialog
Field
Start Time
End Time
Date Type
Action Code
Action Setting
1. Time ranges can not span midnight. To create a rule that spans midnight use two rules.
The first rule starts at the required hour and ends at 12 AM. The second rule starts at 12
AM and ends at the required hour.
4. Press ESC. The system prompts you to save the rule entered.
Tip:
Configuration data is saved to /dbase/admin/operatorhelp.txt.
Tip:
System Date and Time
You should check the system's date and time regularly.
!
WARNING:
Do not change the system date/time while conferences are active. This action
WARNING:
prevents the generation of valid CDRs and CODRs and can cause certain
time-related conference features such as automatic hang-up and termination
tones to work improperly.
68 Administration and Maintenance of the S6200/S6800 Servers
Table
13describes the fields.
Description
1
The start for the time range in hour: minutes: [AM | PM]
The end for the time range in hour: minutes: [AM | PM]
DEFAULT, WEEKDAY, or WEEKEND
Only one action is allowed at one time. Therefore, time ranges
for the same data type can not overlap.
Select WAIT_FOR_HELP, PLAY_MSG, or DIAL_OUT.
Enter the action for the Code. For example, if the code is
PLAY_MSG, enter the message record number. When the
Code is DIAL_Out, enter the Phone number for the system to
dial. The WAIT_FOR_HELP code does not require an action
setting.