Table of Contents
Advertisement
Configuring Warning Tones
You can specify how often warning tones sound during the last 15 minutes of an unattended
conference to notify conferees that the conference is about to end. To implement this feature,
set the Auto Hang-up and Warning Tones parameters to Enabled in the Scheduler
configuration. See
By default, the system sounds warning tones at each of the following intervals before the
conference is scheduled to end:
15 minutes
l
10 minutes
l
5 minutes
l
4, 3, 2, 1 minutes until the conference ends
l
To configure the frequency with which warning tones are sounded:
1. Select System Administrator Main > Configuration > Warning Tone Configuration.
The system displays the
Warning Tone Configuration
+-----------------------Warning Tone Configuration------------------------+
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
+------------------------------ ESC to Exit ------------------------------+
2. Select Y or N under the minute number to specify when you want warning tones to play.
The changes do not affect in-progress conferences, which use the previous configuration.
3. Save (or cancel) your changes.
Note:
The warning tone is a 2-beep tone followed by a 3-beep tone.
Note:
Warning Tones
on page 135 for information on this parameter.
Warning Tone
Specify warning tones to be played for unattended conferences.
The code group configuration must have warning tones enabled.
Specify Y or N for number of minutes before conference end time.
Note: Changes will not affect conferences already in progress.
15
14
13
12
11
Y
N
N
N
Configuration.
10
9
8
7
N
Y
N
N
N
Configuring Warning Tones
6
5
4
3
2
N
Y
N
N
N
Issue 1
August 2007
¦
¦
¦
¦
¦
¦
¦
1
¦
¦
Y
¦
139
Advertisement
Table of Contents
