Avaya S6200 Administration And Maintenance page 288

System and Log Messages
Table 56: Hardware and Device Messages (continued)
Message Code
4107
4108
4109
4110
4111
4112
4113
4114
4115
288 Administration and Maintenance of the S6200/S6800 Servers
Message
Network %d failed- switch: %c,
memory: %s, stream" %d, channel
%d
Network in service - %s channel(s)
[ %s] restored
Network out of service - %s
channel(s) [%s] removed from
service
Unexpected DSP command 0x%d
on annunciator %d
DSP node %d: expected 0x%d got
0x%d at 0x%d
DPM corrupted
DSP node %d - not running
DSP node %d - not responding to
test
DSP node %d test: Undefined
response: 0x%d
Meaning
The memory diagnostic for the
specified network failed for the
indicated switch, memory, stream,
and channel.
Indicates a network trunk has
come into (gone out of) service.
The channel types (for example,
User or Remote Operator) and
channel numbers are variables.
Indicates a network trunk has
come into (gone out of) service.
The channel types (for example,
User or Remote Operator) and
channel numbers are variables.
An announcement or playback
has been requested on the
indicated annunciator which is
busy with the specified command.
During DSP testing, the specified
DSP expected to read one value,
but got another, at the specified
address. If expected value and
read value do match, the host
received the correct value on the
second read.
A process has detected that one
of the circular buffers maintained
in dual-port memory was
corrupted. The command process
or the init process found a problem
with the head of the remove-talker
buffer, or the event process found
a problem with the head of the
event buffer.
During DSP testing, the specified
DSP was not started as desired.
The downloaded DSP test code
does not respond for the specified
test.
The downloaded DSP test code
gave an undefined response to
the specified test.
3 of 6