Avaya S6200 Administration And Maintenance page 277

Table 52: Status Message Definitions (continued)
Message
Code Message
0124 Initiating network device warm restart
0125 No transition found for channel %d,
message 0x%X, state %s
0126 No transition found for channel %d,
message 0x%X, state %s
0127 DSP node %d - got DSP controlled
semaphore %d
0128 Previous call not terminated or multiple
start call on channel %d
0129 Received unknown event 0x%d
0130 Recursive execution of state machine
(%s)
0131 Request for annunciator %d in failed/
active mode
0132 Request for channel %d on failed DSP
node
0133 System database updated
0134 System time has been reset
0135 Timer lost, source process %d tag
0X018X, operation %s
Meaning
Indicates that the network devices (trunks) in
the system are being restarted. Warm indicates
that the current states of the trunk will not be
affected.
Indicates a T1/Call Handler state transition
error. An event has occurred on a channel
which is not defined for the state that the
channel is in. The channel, event, and channel
state are variables. To fully understand the
meaning of the message a thorough knowledge
of the T1 and Call Handler state machines is
required.
Indicates a T1/Call Handler state transition
error. An event has occurred on a channel
which is not defined for the channel's current
state. The channel, event, and channel state
are variables. To fully understand the meaning
of the message, a thorough knowledge of the
T1 and Call Handler state machines is required.
During DSP testing, the host was able to obtain
control of the specified semaphore, which was
expected to be controlled by the specified DSP.
A new call has been declared on a channel; but
the previous call has not been terminated.
Internal debug error only; should not occur in
production software.
The specified event was received from a DSP,
but is not defined.
Internal debug error only, should not occur in
production software.
A request to use the specified annunciator was
received when the annunciator was already in
use or was not usable due to a previously
reported failure.
A request was received to access a channel on
a DSP that had previously failed.
Database updated.
Database updated.
Memory allocation error in the Timer process.
System Messages
4 of 7
Issue 1 August 2007 277