Setting The Maximum Dnis Length System Configuration; Displaying Help For Cbutil - Avaya S6200 Administration And Maintenance

Configuring Channels and Call Routing
Figure 8: Call Entries in the cbutil table
t

Setting the Maximum DNIS Length System Configuration

The maximum DNIS length is set during startup in the shared memory database managed by
the system. However, you can use cbutil dnissize <number> to set this value. Typically, you will
only use this command on a system that is not running the dcbadmin application and, therefore,
has not set this value in the shared memory database.
!
CAUTION:
Using this command on a system that is running will change the setting used by
CAUTION:
ALL other system components. If this setting does not match the system's
configured setting, results will be unpredictable and calls may not go into the
proper conference.
cbutil dnissize <"dnis">
For example, to add an entry to the table when you know the system is configured for four DNIS
digits. Issue the following commands:
cbutil dnissize 4
cbutil add <"dnis"> <msg> <ps> etc.

Displaying Help for cbutil

Use the cbutil command without arguments to display a list of supported commands.
cbutil
To display help for a specific command, use the command name with the -help parameter. For
example to obtain help for the add command, use this syntax:
cbutil add -help
92 Administration and Maintenance of the S6200/S6800 Servers