Avaya S6200 Administration And Maintenance page 290

System and Log Messages
Table 56: Hardware and Device Messages (continued)
Message Code
4122
4123
4124
4125
4126
4127
4128
290 Administration and Maintenance of the S6200/S6800 Servers
Message
DSP node %d test command:
Wrote 0x%d, got 0x%d
DSP node %d test parameter:
Wrote 0x%d, got 0x%d
DSP %d test Mem: After %d
cycles, DSP wrote 0x%d, got
0x%d at 0x%d
DSP node %d Transmission: Sent
0x%d, got 0x%d at 0x%d
device diagnostic completed
MVIP Connection Initialization
Failed, Result %d
DSP node %d: responded to %d
at 0x%d
Meaning
During the specified DSP test, the
specified command was written,
but the DSP got a different one or
did not recognize the command.
During the specified DSP test, the
specified parameter was written,
but the DSP got a different one or
did not recognize the parameter.
After the specified number of
cycles of the specified DSP
memory test, the DSP wrote the
specified value and got a different
one at the specified location.
During the specified MVIP
transmission test, the DSP sent
the specified byte and received a
different value at the specified
word address.
A diagnostic for the specified
device has been completed.
Problems, if any, have already
been logged.
Initialization of the T1/MVIP switch
connection failed with the
specified result code.
During DSP testing, the specified
DSP node responded to a write
request that was intended for the
specified DSP response node at
the specified location.
5 of 6