Chassis installation fundamentals
Upgrade the power supplies before upgrading the modules.
For information about the Ethernet Routing Switch 8800/8600 power supplies and
instructions for installing the chassis, see
installation
The 8003-R chassis includes a single fan tray for cooling. For more information about installing
and replacing a fan tray, see Avaya Ethernet Routing Switch 8800/8600 Routine Maintenance,
NN46205-312.
Figure 4: 8003-R chassis and components
replaceable components in the 8003-R chassis.
Power supplies
The 8010, 8010co, and 8006 chassis provide three bays for power supply installation. The
8003-R chassis provides two bays to accommodate the power supplies.
The following power supplies are supported in chassis for Ethernet Routing Switch
8800/8600.
Table 1: Power supplies supported in chassis in Avaya Ethernet Routing Switch
8800/8600
Power Supply
8004AC
8004DC
8005AC
8005DC
8005DIAC
8005DIDC
The 8010co chassis requires a minimum of two power supplies. You can install an additional
power supply for redundancy.
Note:
The 8001AC and 8002DC power supplies are discontinued for the 8010 and 8006
chassis.
The 8003-R chassis supports the 8005DI-AC power supply, but it is unnecessary due to the
8003-R 1+1 power system redundancy design.
32
Installation — Chassis
on page 55.
8006 and
8010
v
v
v
v
v
v
Comments? infodev@avaya.com
Power supplies
on page 31 also shows the location of customer-
Chassis
8010co
8003-R
v
v
v
v
v
v
v
v
v
v
v
v
on page 32 and
8010co chassis
Notes (if applicable)
approximately 1500 W
approximately 1500 W
approximately 1500 W
approximately 1500 W
approximately 1500 W
approximately 1500 W
November 2012