Set system name Command
Use the set system name command to set mib2 system name MIB variable.
The syntax for this command is:
set system name [<string>]
string
Set system contact Command
Use the set system contact command to set mib2 system contact MIB
variable.
The syntax for this command is:
set system contact [<string>]
string
Set interface Command
Use the set interface command to configure the management interface on the
Master agent of the stack.
The syntax for this command is:
set interface inband <vlan> <ip_addr> <netmask>
inband
vlan
ip_addr
netmask
Example:
Cajun_P330-N# set interface inband 1 192.168.42.252 255.255.255.0
Interface inband IP address set.
You must reset the device in order for the change to take effect.
Avaya P333T User's Guide
System name. The system name is cleared if this field is left blank. A
string of 2 words or more must be type in quotation marks –
e.g. "Backbone Stack".
Contact person. The contact person field is cleared if this field is
blank. A string of 2 words or more must be type in quotation
marks – e.g. "Ygdal Naouri".
Interface name used for the management
The number of the VLAN to be used for management
IP address used for managing the stack
Subnet mask of the management interface
Chapter 6
Cajun Campus CLI – Layer 2
83