Table of Contents
Advertisement
Before
Before printing, backfeed the front part of the next media to the print head position.
•
If you have selected [Tear-Off] or [Partial cutter] in the [Print Mode], only [Before] is
available.
•
If you have selected [Linerless tearoff] or [Linerless cutter] in the [Print Mode], only
[After] is available.
•
If you have selected [Continuous] in the [Print Mode], only [None] is available.
[Eject Cut]
Set the Eject cut motion for the last printed media. Cut the last media after the specified timing.
Appears only if you have selected [Partial cutter] in the [Print Mode] menu.
The setting range is from 0 to 5 (sec).
If you set this to 0, the setting is off.
[Darkness]
Specify the print darkness from 10 steps.
The setting range is from 1 to 10. 1 is the lightest and 10 is the darkest.
•
To further fine tune the print darkness, set [Printing] > [Advanced] > [Adjustments] >
[Darkness Adjust].
[Imaging]
Set the print reference position in the vertical and horizontal directions.
The setting items are as follows:
226
[Imaging]
Advertisement
Table of Contents
