Table of Contents
Advertisement
Prestige 100L IDSL Router
Figure 11-4
11.4.2 Uploading Router Configuration File
The configuration data, system-related data, the error log and the trace log are all stored in the configuration
file. Please be aware that uploading the configuration file replaces everything contained within.
Menu 24.7.2 shows you the instructions for uploading the Router Configuration file. Follow the procedure
below to upload the configuration file:
Step 1.
Enter y at the prompt to go into debug mode.
Step 2.
Enter atur3 after the Enter Debug Mode message.
Step 3.
Wait for the Starting XMODEM upload message before activating Xmodem upload on
your terminal.
Step 4.
After successful firmware upload, enter atgo to restart the Prestige.
If you replace the current configuration file with the default configuration file, i.e., P100L.rom, you loose
all configurations that you had before and the speed of the console port is reset to the default of 9600 bps
with 8 data bit, no parity, 1 stop bit (8n1) and no Flow Control. You need to change your serial
communications software to the default before you can connect to the Prestige again. The password is reset
to the default of 1234, also.
11-4
Menu 24.7.1 - System Maintenance - Upload Router Firmware
To upload router firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
router.
Warning: Proceeding with the upload will erase the current router
firmware.
Do You Wish To Proceed:(Y/N)
Menu 24.7.1 – System Maintenance – Upload Router Firmware
Transferring Files
Advertisement
Table of Contents
Troubleshooting
