Table of Contents
Advertisement
Prestige 681 SDSL Router
Step 1.
Launch the FTP client on your workstation.
Step 2.
Type open and the IP address of your Prestige.
Step 3.
Type root and your SMT password as requested.
Step 4.
Type put firmwarefilename ras where "firmwarefilename" is the name of your
firmware upgrade file on your workstation and "ras" is the remote file name on the Prestige.
Step 5.
The system reboots automatically after a successful firmware upload
11.6.3 Uploading Router Configuration File
The configuration data, system-related data, the error log and the trace log are all stored in the configuration
file. Please be aware that uploading the configuration file replaces everything contained within.
Menu 24.7.2 shows you the instructions for uploading the configuration file. If you answer yes to the
prompt, the Prestige will go into debug mode. Follow the procedure below to upload the configuration file:
Step 1.
Enter "atlc" after the "Enter Debug Mode" message.
Step 2.
Wait for the "Starting XMODEM upload" message before activating Xmodem upload on
your terminal.
Step 3.
After successful firmware upload, enter "atgo" to restart the Prestige.
If you replace the current configuration file with the default configuration file, i.e., P681.rom, you will lose
all configurations that you had before and the speed of the console port will be reset to the default of 9600
bps with 8 data bit, no parity and 1 stop bit (8n1). You will need to change your serial communications
software to the default before you can connect to the Prestige again. The password will be reset to the
default of 1234, also.
11-14
.
System Maintenance
Advertisement
Table of Contents
