Uploading Router Configuration File; Figure 12-18 Menu 24.7.1 - Uploading Router Firmware - ZyXEL Communications Prestige 202 User Manual

To upload router firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
XMODEM upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
router.
Warning: Proceeding with the upload will erase the current router
firmware.
Figure 12-18 Menu 24.7.1 – Uploading Router Firmware

12.7.2 Uploading Router Configuration File

The configuration data, system-related data, the error log and the trace log are all stored in the
configuration file. Please be aware that uploading the configuration file replaces everything
contained within.
Menu 24.7.2 shows you the instructions for uploading the configuration file. If you answer yes to
the prompt, the Prestige will go into debug mode. Follow the procedure below to upload the
configuration file:
1. Enter "atlc" after the "Enter Debug Mode" message.
2. Wait for the "Starting XMODEM upload" message before activating XMODEM upload
on your terminal.
3. After successful firmware upload, enter "atgo" to restart the Prestige.
If you replace the current configuration file with the default configuration file, i.e., p202.rom, you
will lose all configurations that you had before and the speed of the console port will be reset to
the default of 9600 bps with 8 data bit, no parity, 1 stop bit (8n1) and no Flow Control. You will
need to change your serial communications software to the default before you can connect to the
Prestige again. The password will be reset to the default of 1234, also.
System Maintenance
Menu 24.7.1 - System Maintenance - Upload Router Firmware
Do You Wish To Proceed? (Y/N)
Prestige 202 ISDN Router
12-17