Ricoh fax3900l User Manual page 81

Shm4ENfaxF.book Page 63 Wednesday, September 13, 2000 3:13 PM
Problem
The original is not pulled into
the auto document feeder.
Frequent original misfeeds
(Multifeeds)
Frequent original misfeeds
(Non-feeds)
Transmission cannot take place;
" Clear Misfed Orig.
pears.
Required Action
The dialed number did not have enough pauses between the
outside line access number and the telephone number.
Try adding more pauses after the outside line access num-
ber.
Incorrect positioning of originals. Position the document in
the feeder correctly. See P.11 "Memory Transmission".
Incorrect alignment of originals. Align the edges of the doc-
ument. See P.10 "Suitable Document Types".
Curled pages. Flatten the document. See P.10 "Suitable Doc-
ument Types".
Incorrect document type. Use a proper document type. See
P.10 "Suitable Document Types".
Mixed document types. The pages must all be of the same
type.
Static electricity on the originals. Shuffle the document. See
P.11 "Memory Transmission".
Do user maintenance, especially rollers (2) and (6). See the il-
lustration in Chapter 9, "Cleaning the Rollers and Exposure
Glass" in the Advanced Features manual.
Copier silicone oil on the originals. Wait a few minutes, then
try again.
Incorrect alignment of originals. Align the edges of the doc-
ument. See P.11 "Memory Transmission".
Curled pages
Flatten the document. See P.10 "Suitable Document Types".
Incorrect document type. Use a proper document type. See
P.10 "Suitable Document Types".
More than 50 pages in the feeder. Do not load more than 50
pages in the automatic document feeder at once.
Do user maintenance, especially rollers (2) and (6). See the il-
lustration in Chapter 9, "Cleaning the Rollers and Exposure
Glass" in the Advanced Features manual.
The document is jammed in the feeder.
" ap-
Remove the jammed document. See P.55 "Clearing a Docu-
ment Jam" .
The document may be longer than the maximum limit.
Make sure that none of your originals exceed this limit.
Do user maintenance, especially rollers (2) and (6). See the il-
lustration in Chapter 9, "Cleaning the Rollers and Exposure
Glass" in the Advanced Features manual.
Solutions to Common Problems
4
63