Primary Charger Load Current Calibration - Oki LP-1040 Maintenance Manual

10.1.1

Primary Charger Load Current Calibration

Note
Depending on when your unit was manufactured, it may be made up of only one or two different
circuit boards. This section will describe the adjustment procedures for both configurations.
(1) One circuit board configuration
1.
Perform the procedure below so that the front
power supply unit is visible.
(a) Remove the electrical box access cover
(see p. 9-7).
(b) Remove the COVER-FRONT.
10-2
Eight screws on the front
COVER-FRONT
Electrical box access cover
Four screws on the top side