Oki LP-1040 Maintenance Manual page 295

(3) Removing the side cover (upper left)
<Removal>
1.
Remove the toner cartridge and remove the
top cover (see p. 9-5).
2.
Open the fuser unit drawer.
3.
Open the drawer for roll 1.
4.
Remove the electrical box access cover
(see p. 9-7).
5.
Remove the five screws as shown in the
photo:
- Top one screw;
- Front two screws; and
- Back two screws
6.
Take note of the cautionary notice below.
Lightly push the top panel forward and lift up
to remove.
Note
 Be careful not to tilt too hard as the clamps on
the lower part of the cover may break.
 The screw area on the lower side of the front
can break easily as it is in the way of a metal
plate.
Spread this area out to the outside with your
fingers while tilting the cover.
9-8
Side cover (upper left)