Oki LP-1040 Maintenance Manual page 100

The printer restarts automatically after the HDD has been formatted. The following operations must
be performed next (follow the messages prompting you to perform these operation that are
displayed in order on the operation panel).
(1) The message Setup data is incorrect indicating a setup corruption error is displayed on
the panel. Press the Enter button to initialize the setup data.
(2) Adjust the panel.
(3) Set the language.
(4) Perform the initial settings.
(5) Set the date and time.
(6) Set the IP address.
(7) The printer restarts automatically again. After the printer has restarted, configure the items
that have been initialized as necessary.
(4) Special Settings 3
How to launch: Menu -> Printer Engine
Do not change these settings.
(5) Enterprise ID
How to launch: Menu -> System -> Communication Parameters -> Network Settings ->
Common Settings
Sets the SNMP enterprise ID response.
OKI: The response is the OKI enterprise ID. (default)
SII: The response is the SII enterprise ID.
Generally, OKI should be used for the enterprise ID.
The SII enterprise ID should be used only in case the printer has been replaced and cannot
connect to upstream systems without the SII enterprise ID.
It is recommended to modify the upstream system instead when possible.
Chapter 3 Regular Service Inspectionse
2-51