Oki LP-1040 Maintenance Manual page 321

<Installation>
1.
Return the CUTTER UNIT AUTO to its
original position and temporarily secure the
brackets with four screws.
Note
CUTTER UNIT AUTO bracket
2.
Push down on the bracket with your hand
when tightening the screws so that there is
no space between the cutter.
Cautionary Notes When Performing
Installation
First fix the left bracket, and the right one based
on the left one.
3.
Reconnect the two previously disconnected
connectors and install the COVER-CUT with
seven screws that you removed.
4.
After installation, feed paper through to
confirm proper operation, with which the
paper is cut properly.
Note
Perform the steps in Cut Squareness Calibration
if necessary.
9-34