Oki LP-1040 Maintenance Manual page 650

Initial
No.
Value
53 2081
54 2081
Monochrome original scan start sensor parameters
Initial
No.
Value
55 1705
56 2547
57 8832
58 2547
59 96
60 6476
61 11873
62 2547
11-52
Unit Range
━
line Number of scan lines after the original rear
edge passed the registration sensor in
synchro scan mode, with CIS(C) as a
reference
━
line Number of scan lines after the original rear
edge passed the registration sensor in
synchro scan mode, with CIS(C) as a
reference
Unit Range
━
pulse The parameter involves the original in satndby
nipped nipped in the registration roller.
Motor pulse count from the scan start request
until the top edge of the original reaches the
registration sensor.
━
pulse Jam detection width
The parameter involves the original in satndby
nipped nipped in the registration roller.
The length of the top edge of the original varies
depending on the original type or the original
insertion timing. So the jam detection width
should be widened.
━
pulse Motor pulse count until the original rear edge
reaches the registration sensor after a rewind
request (with front output)
━
pulse Jam detection width
━
pulse Maximum advance length setting (motor pulse
count maximum value from original presence
detection to absence detection)
The Printer stops when the value is exceeded.
━
pulse Maximum advance length setting (maximum
motor pulse count from original presence
detection to absence detection)
The Printer stops when the value is exceeded.
━
pulse After scan started, motor pulse count from the
time the original top edge passes the
registration sensor until it reaches the paper
output sensor
━
pulse Jam detection width
Meaning
Meaning
Changes
after Note
Calibration
━
At 60 mm/s
━
At 40 mm/s
Changes
after Note
Calibration
━
━
━
━
━
No.59 and No.60
are combined and
used as one
parameter
Parameter =
No.59 x16384 +
No.60
━
No.59 and No.60
are combined and
used as one
parameter
Parameter =
No.59 x16384 +
No.60
━
━