4.
After attaching all separating claws, install the
PROCESS CARTRIDGE UNIT.
5.
Check for proper paper separation.
(a) Prepare tracing paper 60 of about 30 mm
(1.18 inches) x 50 mm (1.97 inches) in
size.
(b) As the paper top edge moves along the
paper path, check that there is resistance
as the paper catches when it touches the
separating claws.
Note
Use the DRUM FINGER MNT when replacing the PROCESS CARTRIDGE 60 UNIT (for tracing
paper 60). The replacement procedure is the same as shown above.
9-152