9.8.11
[HV-PS] HV(4CH)-PSU-T2 MNT
Note
Depending on when your high voltage power unit was manufactured, it may be made up of only
one or two different circuit boards.
If the high voltage power unit contains only one circuit board
The board is [HV-PS] HV(4CH)-PSU-T2 MNT.
-> (a) See One circuit board configuration removal ([HV-PS] HV(4CH)-PSU-T2 MNT).
If the high voltage power unit contains two circuit boards
The boards are the HV-PSU-LSP2 MNT and HV(TC)-PSU-T2 MNT.
-> (b) See Two circuit board configuration removal (HV-PSU-LSP2 MNT,
To change two circuit board configuration into a single circuit board configuration.
-> (c) See Changing a two circuit board configuration (HV-PSU-LSP2 MNT,
(a)
One circuit board configuration removal ([HV-PS] HV(4CH)-PSU-T2 MNT)
<Removal>
1.
Perform steps 1 through 10 in the instructions
for replacing the PSU-T2 MNT (see p. 9-65)
so that the circuit board can be removed.
2.
Unplug all connectors connected to the board.
Also remove them from their cable clamps.
9-72
HV(TC)-PSU-T2 MNT).
HV(TC)-PSU-T2 MNT) to a one circuit board configuration
([HV-PS] HV(4CH)-PSU-T2 MNT).
HV-PS