Aac] Pcb-Assy-Aac1 Mnt - Oki LP-1040 Maintenance Manual

9.8.2

[AAC] PCB-ASSY-AAC1 MNT

<Removal>
1.
Remove the COVER-BACK(L)
(see p. 9-52).
2.
Unplug all the connectors connected to the
AAC board.
The number of connectors differs depending
on the printer model as follows:
LP-1040 (one roll model): 11 connectors
LP-1040 (two roll model): 12 connectors.
3.
Remove the six screws securing the board
and remove AAC.
Note
When removing the board, pay attention to CN2
on PCB-ASSY-AAC as it is connected to
PCB-ASSY-ARC.
Cautionary Notes When Replacing Board
 Set the SW2 to the status at the replaced board (see p. B-2).
 Do not change the SW1 setting.
9-54
(The board structure varies by model.)
AAC