Oki LP-1040 Maintenance Manual page 561

(2) Calibrate the cut length with the conditions and ideal values you know beforehand
The calibration procedure below is recommended, for example, when:
- You need to extend or shorten the A2 plain paper's cut length by a few mm.
1.
Enter Engine Maintenance Mode and select Parameters.
2.
Input the engine control parameter number.
- Select the engine control parameter number that matches the print length and roll paper
conditions you desire.
3.
Convert the calibration value (mm) to the number of lines (lines/sec), then set the converted
value as the calibration value.
See step 6 in subsection (1) above for details on the calibration procedure.
4.
If you want to adjust the cut length with any other changed test conditions, repeat steps 2 and
3.
5.
Save the value to the EEPROM.
6.
Print a test plot by executing Positioning ->Cut Length Adjustment, then check the cut length
after the adjustments.
- Check all codes you used to calibrate the cut length.
- Make sure to match up the test conditions and print conditions for each code you calibrated.
See 2.3.13 Positioning (p. 2-28).
See 7.2.1 Print Specifications and How to Measure Them (p. 7-4) No.6 for measuring
methods and standard values.
Chapter 10 Printer Calibrationt
10-29