Roller Sc G Assy Mnt - Oki LP-1040 Maintenance Manual

9.15.4

ROLLER SC G ASSY MNT

The following section describes the steps to remove the front roller of the two ROLLER SC G
ASSY In the SCANNER UNIT.
The rear roller can be removed by following these same instructions.
Note
When installing the front side roller, you must secure the screws only after aligning the position in
the same way as the installation of CIS UNIT, which is discussed later in this chapter.
<Removal>
1.
As explained in the previous section [PSS11]
REFLECTIVE PHOTOSENSOR MNT
(behind CIS unit), remove the scanner cover
and lean it against the side of the Printer.
Note
Be careful not to knock over the scanner cover
while working.
2.
Remove the plate with two screws from the
right side of the Printer at the location shown
in the photo.
9-188